Design analysis of 2,000 lb JIB crane for chemical lab

A 2,000 lbf jib crane is needed to replace an existing 1,000 lbf jib crane in the Chemical Lab (Building MO-733). The existing 1,000 lbf jib crane (to be replaced) has a 174 boom (I-beam). The crane is attached to the wall through two brackets (about 8 1/2-ft apart). The boom is attached to the lower bracket, and a supporting rod is attached to the upper bracket. The supporting rod is attached to the boom at about 8-ft from the free end. After preliminary studies and discussions, it was decided to construct the new jib crane from two perpendicular I-beams (L-shape) without a supporting rod. The crane is to be supported on the wall through the two lower existing brackets (about 5-ft apart). The boom is to be 20-ft long cantilever (the horizontal I-beam). The vertical I-beam is to be attached to the lower two existing brackets to support the jib crane to the wall. This construction is to be similar to another existing 1,000 lbf jib crane (L-shape) in the lab. The purpose of this document is to perform a design analysis for the proposed 2,000 lbf jib crane to determine suitable sizes of members and configuration of the new jib crane assembly. After construction, if the as-built assembly differs from the 2,000 lbf jib crane as proposed in this document, a revision of this analysis needs to be performed to confirm the acceptability of the as-built assembly