Thermal calculations pertaining to experiments in the Yucca Mountain Exploratory Shaft

A series of thermal calculations have been presented that appear to satisfy the needs for design of the Yucca Mountain Exploratory Shaft Tests. The accuracy of the modeling and calculational techniques employed probably exceeds the accuracy of the thermal properties used. The rather close agreement between simple analytical methods (the PLUS Family) and much more complex methods (TRUMP) suggest that the PLUS Family might be appropriate during final design to model, in a single calculation, the entire test array and sequence. Before doing further calculations it is recommended that all available thermal property information be critically evaluated to determine "best" values to be used for conductivity and saturation. Another possibility is to design one or more of the test sequences to approximately duplicate the early phase of Heater Test 1. In that experiment an unplanned power outage for about two days that occurred a week into the experiment gave extremely useful data from which to determine the conductivity and diffusivity. In any case we urge that adequate, properly calibrated instrumentation with data output available on a quasi-real time basis be installed. This would allow us to take advantage of significant power changes (planned or not) and also help "steer" the tests to desired temperatures. Finally, it should be kept in mind that the calculations presented here are strictly thermal. No hydrothermal effects due to liquid and vapor pressures have been considered