Progress report on pre-test calculations for the large block test

The U.S. Department of Energy`s (DOE) Yucca Mountain Site Characterization Project (YMP) is investigating the suitability of the Topopah Spring tuff in the thick vadose zone at Yucca Mountain, Nevada, as a host rock for permanent disposal of high-level radioactive waste. As part of the YMP, a group of field tests, referred to as the Large Block Test (LBT), will be conducted on a large electrically heated block of Topopah Spring tuff, isolated at Fran Ridge, Nevada Test Site. The block, which will be 3 x 3 m in horizontal dimensions and 4.5 m in height, will be heated by electrical heaters. The goals of the LBT axe to gain information on the coupled thermal-mechanical-hydrological-chemical processes active in the near-field environment of a repository; to provide field data for testing and calibrating models; and to help the development of measurement systems and techniques. This progress report presents results of on-going numerical modeling calculations carried out in support of the LBT design. An equivalent continuum model with an upper boundary temperature of 60{degrees}C was used to simulate the hydrothermal response of the block to heating over a one-year period. The total heating power was started at 1500 W and later reduced to maintain an approximately uniform temperature of 138-140{degrees}C. For a homogeneous bulk permeability case, the results show the formation of a distinct dry-out zone in and around the heater plane, and well-developed condensation zones above and below the heater plane. For a heterogeneous permeability distribution, the condensation zone above the heater plane was not well developed. This difference in results suggests that water saturation changes might be sensitive to changes in bulk permeability distribution. Rock temperatures were almost unaffected by permeability distribution. Heat flow was dominated by conduction. No liquid flow through the top of the block was predicted