Manufacturing and metallization of hybrid thermoplastic-thermoset matrix composites

Metallization is a common strategy employed to enhance the electrical and thermal conductivity of polymer matrix composite materials. Nevertheless, metallic deposition on polymer-based materials is challenging due to the inherent limitations related to high temperature exposure of the substrate. In this article, a new technique for the manufacturing of composite laminates and the subsequent metallization by cold spraying of metallic powder is presented. The composite manufacturing route is based on the production of thermoplastic-thermoset hybrid substrates and consisted of two main stages: in the first stage the partial impregnation of a reinforcement textile by a thermoplastic film was promoted by hot pressing compaction. Afterwards, the prepared lamina was vacuum bagged with other reinforcing layers and impregnated by the thermoset catalyzed resin by a vacuum infusion process. Finally, the thermoset and thermoplastic layers were co-cured to increase the adhesion of the substrate with the thermoplastic film. The metallization of composite laminate was obtained through the cold spraying technique, depositing powders on the thermoplastic surface layer. The effect of processing parameters on the coating deposition, quality and microstructure was reported and discussed