Design of the European DEMO vacuum vessel inboard wall

The pre-concept design of the DEMO Vacuum Vessel is going on in view of the 2020 gate review; moreover the nuclear heat loads on the vessel inner shell were determined and found to be about one order of magnitude higher compared to ITER. A subsequent thermal-structural analysis of the vessel inner shell revealed high thermal stresses and a large temperature gradient through the inner shell thickness. Given the simultaneous occurrence of primary membrane stresses in the entire vessel inboard wall and, in proximity of the vessel ribs, high bending stresses due to the coolant pressure, a survey of all options within the design rules was required to identify the inter-dependencies of the individual stress limits (primary membrane, primary bending, thermal membrane plus bending). In order to face this kind of issues a detailed assessment on the design of the inboard wall of DEMO Vacuum Vessel has been conducted and is presented here. The current work evaluates both P and S type damages for the inboard wall of DEMO Vacuum Vessel in case of high nuclear heat load, vacuum vessel coolant pressure and toroidal field coil fast discharge. The elastic analysis method has been used to check the rules for prevention of both types of damage. The rules applied to prevent the aforementioned damages are compliant to Level A criteria, in case of negligible creep and negligible irradiation. In order to check the structural integrity of the inboard wall of DEMO VV against high thermal and mechanical loads, optimization structural analyses were performed and checked against the rules provided in the applicable design code (RCC MRx)