Nanoparticle engineering processes: evaporative precipitation into aqueous solution (EPAS) and antisolvent precipitation to enhance the dissolution rates of poorly water soluble drugs

textIt is estimated that more than 1/3 of the compounds being developed by the pharmaceutical industry are poorly water soluble. The bioavailability of these drugs is limited by their low dissolution rates. Two nanoparticle engineering processes, evaporative precipitation into aqueous solution (EPAS) and antisolvent precipitation were developed to enhance the dissolution rate of poorly water soluble drugs. EPAS is a process by which a drug solution in a water immiscible organic solvent is sprayed through an atomizer into an aqueous solution containing hydrophilic stabilizer (s) at high temperature. The rapid evaporation of the small organic droplets results in fast nucleation leading to submicron to micron particles suspensions. The adsorption of water soluble stabilizers on the drug particle surfaces facilitates the dissolution rates of the final powder after drying. The suspensions may be used in parenteral formulations to enhance bioavailability or may be dried to produce oral dosage forms with high dissolution rates due to small particle size and hydrophilic stabilizer that enhances wetting. The influence of EPAS process parameters on the physicochemical properties of poorly water soluble drugs was determined. The influence of the dissociation of drug molecules on the stability of nanosuspensions at high suspension concentration, as high as 30 mg/ml with a drug-to-surfactant ratio of 3:1, was investigated. High-potency (≥ 90%) drug particles with high dissolution rates were produced by removing the non-adsorbed surfactant. Antisolvent precipitation is a technique where a drug solution in a water miscible organic solvent is mixed with an aqueous solution containing a surfactant(s). Upon mixing, the supersaturated solution leads to nucleation and growth of drug particles, which may be stabilized by surfactants. Temperature was shown to have a large effect on the particle size distribution in the suspension. Crystalline drug particles with particle size of 300 nm were successfully recovered from the nanosuspensions by salt flocculation followed by filtration and vacuum drying with a drug yield higher than 92%. Upon redispersion, the average particle size was comparable to the value in the original aqueous suspension. The dissolution rate was correlated with the particle size after redispersion.Chemical Engineerin