The authors regret that a technical mistake has been discovered, which impacts the current density and power density reported in this article. Briefly, the mistake was caused by catalyst solution leaking out of the intended 1 cm2 catalyzed area and depositing catalyst over the whole cell. As a result, the calculated current and power densities (total divided by the catalyzed area) were higher than reality because the measured current and power were dividing by the intended 1 cm2 instead of the actual area including the leakage, which was approximately 5 cm2. This issue is presented, analysed, and discussed in further detail in the supporting information of Reference 1. The authors would like to apologise for any inconvenience caused
The authors regret an error in the Fig. 2(d) caption. The text "U=1.3 V" in the published version sh...
The authors regret that there were some inaccuracies in the above article. In Table 2, the values of...
This article has been published under the category Technical paper instead of Original scientific pa...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
Page 8372 in section 2.3. ORR Kinetics. There is an error in the sentence "The effective surface of ...
Page 8372 in section 2.3. ORR Kinetics. There is an error in the sentence "The effective surface of ...
Page 8372 in section 2.3. ORR Kinetics. There is an error in the sentence "The effective surface of ...
Page 8372 in section 2.3. ORR Kinetics. There is an error in the sentence "The effective surface of ...
Volume 206, Number 1 (February 15, 2002), in the research note Hydrogen Spillover from a Metal Oxid...
The publisher regrets that caption text has been incorrectly placed for Figures 5 and 8. The correc...
The authors regret an error in the Fig. 2(d) caption. The text "U=1.3 V" in the published version sh...
The authors regret that there were some inaccuracies in the above article. In Table 2, the values of...
This article has been published under the category Technical paper instead of Original scientific pa...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
The authors regret that a technical mistake has been discovered, which impacts the current density a...
Page 8372 in section 2.3. ORR Kinetics. There is an error in the sentence "The effective surface of ...
Page 8372 in section 2.3. ORR Kinetics. There is an error in the sentence "The effective surface of ...
Page 8372 in section 2.3. ORR Kinetics. There is an error in the sentence "The effective surface of ...
Page 8372 in section 2.3. ORR Kinetics. There is an error in the sentence "The effective surface of ...
Volume 206, Number 1 (February 15, 2002), in the research note Hydrogen Spillover from a Metal Oxid...
The publisher regrets that caption text has been incorrectly placed for Figures 5 and 8. The correc...
The authors regret an error in the Fig. 2(d) caption. The text "U=1.3 V" in the published version sh...
The authors regret that there were some inaccuracies in the above article. In Table 2, the values of...
This article has been published under the category Technical paper instead of Original scientific pa...