Experimental study of fixed and fluidized beds of PCM with an internal heat exchanger

This work presents the results of experiments performed in a thermal energy storage tank filled with particles, which was heated using hot air and then discharged with a cold water stream circulating inside a heat exchanger immersed in the bed. Both fixed- and fluidized-bed configurations were studied. The materials used were sand, which is a material commonly employed in sensible heat storage, and a granular phase change material (PCM), in which the phase change occurs over the temperature range of 4050 degrees C. Three different heat exchangers with different helical coil geometries were tested by measuring the temperatures in the bed and at the water inlet and outlet. Higher heat transfer coefficients between the bed and the water flow and higher heat exchanger effectiveness were observed for the heat exchanger with the greatest distance between coils, as it allows better contact between the bed particles and the heat exchanger surface when the particles are fluidized. (C) 2016 Elsevier Ltd. All rights reserved.This work was partially funded by the Spanish Government (Project ENE2010-15403), the regional Government of Castilla-La Mancha (Project PPIC10-0055-4054) and Castilla-La Mancha University (Project GE20101662)