Tests conducted at NASA-Langley have shown that a small flap or strake can generate a significant amount of lift on a circular cylinder with large cross flow. If strakes are placed on the opposite sides and ends on a circular body, a moment will be produced about the center of mass of the body. The purpose of this test was to determine the static-aerodynamic forces and moments of a 162-inch diameter SRB (PRR) with and without strakes. The total angle-of-attack range of the SRB test was from -10 to 190 degrees. Model roll angles were 0, 45, 90, and 135 degrees with some intermediate angles. The Mach range was from 0.6 to 3.48. The 0.00494 scale model was designated as MSFC No. 449
Experimental aerodynamic investigations were conducted in the NASA/MSFC 14-inch trisonic wind tunnel...
Supersonic phase of 0.0088105 scale MSC orbiter/booster test in four ft high speed wind tunne
Wing and lower body surface static pressure data for the space shuttle 049 orbiter while in the laun...
Tests of a 2.112 percent scale model of the space shuttle solid rocket booster model were conducted ...
A force test of a 2.112 percent scale Space Shuttle Solid Rocket Booster (SRB), MSFC Model 454, was ...
Force tests of a 0.563 percent scale space shuttle solid rocket booster (SRB) model, MSFC Model 449,...
An experimental investigation (SA16F) was conducted in the AEDC PWT 4T to determine the entry static...
A test of a 0.563 percent scale space shuttle Solid Rocket Booster (SRB) model, MSFC Model 449, was ...
An experimental investigation (SA14FA, TWT 620) was conducted in the MSFC 14-inch Trisonic Wind Tunn...
The results of a pressure test of a .00548 scale 146 inch Space Shuttle Solid Rocket Booster (SRB) w...
A force test of a scale model of the Space Shuttle Solid Rocket Booster was conducted in a trisonic ...
An experimental investigation was conducted in the MSFC 14 inch TWT to study the roll characteristic...
Additional technical data have been prepared to supplement the data supplied in the SRM shuttle boos...
Wind tunnel tests were conducted to determine the aerodynamic interference between the space shuttle...
An experimental aerodynamic investigation was conducted in the NASA/MSFC 14-inch Trisonic Wind Tunne...
Experimental aerodynamic investigations were conducted in the NASA/MSFC 14-inch trisonic wind tunnel...
Supersonic phase of 0.0088105 scale MSC orbiter/booster test in four ft high speed wind tunne
Wing and lower body surface static pressure data for the space shuttle 049 orbiter while in the laun...
Tests of a 2.112 percent scale model of the space shuttle solid rocket booster model were conducted ...
A force test of a 2.112 percent scale Space Shuttle Solid Rocket Booster (SRB), MSFC Model 454, was ...
Force tests of a 0.563 percent scale space shuttle solid rocket booster (SRB) model, MSFC Model 449,...
An experimental investigation (SA16F) was conducted in the AEDC PWT 4T to determine the entry static...
A test of a 0.563 percent scale space shuttle Solid Rocket Booster (SRB) model, MSFC Model 449, was ...
An experimental investigation (SA14FA, TWT 620) was conducted in the MSFC 14-inch Trisonic Wind Tunn...
The results of a pressure test of a .00548 scale 146 inch Space Shuttle Solid Rocket Booster (SRB) w...
A force test of a scale model of the Space Shuttle Solid Rocket Booster was conducted in a trisonic ...
An experimental investigation was conducted in the MSFC 14 inch TWT to study the roll characteristic...
Additional technical data have been prepared to supplement the data supplied in the SRM shuttle boos...
Wind tunnel tests were conducted to determine the aerodynamic interference between the space shuttle...
An experimental aerodynamic investigation was conducted in the NASA/MSFC 14-inch Trisonic Wind Tunne...
Experimental aerodynamic investigations were conducted in the NASA/MSFC 14-inch trisonic wind tunnel...
Supersonic phase of 0.0088105 scale MSC orbiter/booster test in four ft high speed wind tunne
Wing and lower body surface static pressure data for the space shuttle 049 orbiter while in the laun...