Add to ORKGThe master thesis deals with the use of the Sinumerik 840D control system for programming of blanks for gear manufacturing. The first part of the thesis is focused on analysis of machinability of the material followed by experimental testing of machinability of material 16MnCr5. An experimental evaluation of the effect of cutting parameters was carried out to force load of semi roughing cutting tool CoroTurn 300. In the next part of the thesis there is a technical documentation of gearing parts, for which a NC program is created. Finally, the possibilities of using the Sinumerik 840D control system are listed and demonstrated by workshop-oriented programming of the considered components for the SP 280 SY turning center