The predictive model for strength of inclined screws as shear connection in timber-concrete composite floor

Interest in timber-concrete composite (TCC) floors has increased over the last 30 years. TCC technology relies on timber and concrete members acting compositely together. Both timber and concrete exhibit a quite brittle behaviour in bending/tension and compression respectively whilst the shear connection is identified as the only contributor of ductile behaviour. Therefore, the strength, stiffness and arrangement of the shear connection play a crucial role in the structural design of TCC. There are only few investigations on analytical closed-form equation to predict the stiffness and strength of TCC joints as input values to design a partially composite floor. For example, Johansen’s yield theory was adopted as European yield model in Eurocode 5. However, the equations are limited to vertically inserted dowels or screws and Eurocode 5 recommends that the strength and stiffness of unconventional joints should be determined by push-out tests. Previous investigations reported that the inclined shear connector significantly increase the initial stiffness and ultimate strength of the TCC joints and consequently composite floor. This paper presents a model for the strength ofTCC joint using crossed (±45°) proprietary screws (SFS Intec). The Johansen yield theory is extended to derive the strenght model of TCC joint with crossed (±45°) screws which are loaded in tension and compression. The model is an upper bound plastic collapse model that assumes the behaviour of timber and screw perfectly plastic with undamaged concrete. The failure modes considers of yield of screw, in tension or shear, and some combined modes assuming screw withdrawal, lateral crushing of the timber and the development of plastic hinges in the screw. The experimental aspect of the research consists of push-out tests and aims to verify the strength model of TCC joints with inclined screws. The failure modes are also investigated. The model seems to be reasonably accurate in predicting both the characteristic strength and failure mode. This research suggests the model to facilitate the design of inclined screw shear connections for TCC construction