Overview of magnet design options: Deliverable D5.1

This document describes the design options for 16 T superconducting dipole magnets for the FCC hadron collider explored in the frame of the activities of WP5. All options have been considered under comparable assumptions and managed using the same tools to ensure a correct judgement and comparison of their relevant pros and cons. Three baseline design configurations have been explored: 1) block-coils, 2) cosine-theta and 3) common-coils. A fourth option, the canted cosine-theta, has been initiated by Swiss (PSI, not part of EuroCirCol) and US (LBNL, EuroCirCol partner) laboratories. The studies show that, adopting a reference margin to the load line of 14 % and with reasonable assumptions on the conductor performance, the total amount of conductor needed for the entire collider is between 7.5 and 10 ktons. depending on the option. The cosine-theta uses less conductor and the canted cosine-theta uses the largest amount. The characterisation of the magnet design options is complete and the work to finalize and compare these options in the subsequent deliverable D5.2 (identification of preferred dipole design options and cost estimates) has started