We investigated the synergetic effect between light-emitting diode (LED) lighting efficiency and building energy savings in heating and cooling using an alternative thermal operating system (ATOS) of indoor LED lighting integrated with the ventilation system of a building as an active cooling device. The heat generated from LED lighting and the indoor lighting illuminance were experimentally determined. The indoor heat gains in cooling and heating periods were determined using measurement data; the annual energy savings of an office building in heating and cooling were calculated through simulation. The LED lighting illuminance increased by approximately 40% and the lighting contribution for indoor heat gain was 7.8% in summer, while 69.8% ...
Energy saving in lighting has been seen as an important issue in recent years due to the increasing ...
A simple method is proposed to measure the heat dissipation of LEDs and fluorescent lamps in an open...
The aim of the project was to demonstrate the energy savings that can be achieved by the installatio...
We investigated the synergetic effect between light-emitting diode (LED) lighting efficiency and bui...
Light-emitting diode (LED) lighting should be considered for lighting efficiency enhancement, howeve...
AbstractIn relation to recent attention focused on the use of energy by lighting, there is a large p...
Vertical windows are the most common and simplest method to introduce daylight to interior spaces of...
The aim of the Authors is to study and compare, through in situ measurements and modeling software, ...
Most building retrofit projects are still component-based in that they typically address only one pi...
People spend much of their time in buildings. This means the indoor environment (temperature, light,...
More than one third of a buildings’ energy consumption is designated for heating and cooling. Theref...
Energy saving approaches for interior lighting, especially for governmental and nongovernmental offi...
EU directives and the Construction Law have for some time required investors to report the energy co...
Based on recent developments and the predicted future advancement of lighting technologies, research...
Detailed simulations of lighting and HVAC energy consumption were performed on a prototype office bu...
Energy saving in lighting has been seen as an important issue in recent years due to the increasing ...
A simple method is proposed to measure the heat dissipation of LEDs and fluorescent lamps in an open...
The aim of the project was to demonstrate the energy savings that can be achieved by the installatio...
We investigated the synergetic effect between light-emitting diode (LED) lighting efficiency and bui...
Light-emitting diode (LED) lighting should be considered for lighting efficiency enhancement, howeve...
AbstractIn relation to recent attention focused on the use of energy by lighting, there is a large p...
Vertical windows are the most common and simplest method to introduce daylight to interior spaces of...
The aim of the Authors is to study and compare, through in situ measurements and modeling software, ...
Most building retrofit projects are still component-based in that they typically address only one pi...
People spend much of their time in buildings. This means the indoor environment (temperature, light,...
More than one third of a buildings’ energy consumption is designated for heating and cooling. Theref...
Energy saving approaches for interior lighting, especially for governmental and nongovernmental offi...
EU directives and the Construction Law have for some time required investors to report the energy co...
Based on recent developments and the predicted future advancement of lighting technologies, research...
Detailed simulations of lighting and HVAC energy consumption were performed on a prototype office bu...
Energy saving in lighting has been seen as an important issue in recent years due to the increasing ...
A simple method is proposed to measure the heat dissipation of LEDs and fluorescent lamps in an open...
The aim of the project was to demonstrate the energy savings that can be achieved by the installatio...