Flat acoustic sources with frequency response correction based on feedback and feed-forward distributed control

This paper presents an acoustic source with a small thickness and high bending stiffness. The high bending stiffness is obtained with a sandwich structure in which the face of the sandwich structure internal to the source is perforated to increase the acoustic compliance, thereby leading to increased electroacoustic conversion efficiency. Multiple actuators are used to drive the moving component of the acoustic source. Control of the acoustic resonances and structural resonances is required to obtain an even frequency response. The use of collocated decentralized feedback control based on velocity sensing was found to be ineffective for controlling these resonances due to the destabilizing asymmetric modes caused by the coupling of the internal acoustic cavity and the rigid body vibration of the moving component. Resonances can be controlled by a set of independent combinations of symmetric driving patterns with corresponding velocity feedback controllers such that the fundamental mass-air resonance is effectively controlled, as is the lowest bending mode of the moving component. Finally, a compensation scheme for low frequencies is used which enables a flat frequency response in the range of 30 Hz to 1 kHz with deviations smaller than 3 dB