Simulation and Experimental Analysis of a Demonstrative Solar Heating and Cooling Plant Installed in Naples (Italy)

In this study the model of a Solar Heating and Cooling (SHC) system and its experimental setup are presented. The SHC system under investigation is a demonstration plant installed in Naples, based on flat plate solar collectors and a single-stage LiBr-H2O absorption chiller. In addition, two vertical tanks are installed as storage system. The balance of system includes: A cooling tower, pumps, valves, safety devices and pipes. The absorption chiller is powered only by solar energy, since there are devices for auxiliary thermal energy. The experimental setup also includes a number of meters (temperature, pressure, flow rate and radiation) to measure, collect and control the prototypal system. The experimental plant is dynamically designed and simulated in order to calculate its energetic and economic performance parameters. This analysis is carried out by means of a zero-dimensional transient simulation model, developed by using the TRNSYS software. Furthermore, a parametric analysis is implemented, aiming at determining the set of the synthesis/design variables that maximize system performances. The model was validated by the first experimental results obtained by the operation of the solar cooling system. Results show that, although flat-plate solar collectors have been specially designed for this kind of application, their operating temperature is often too low to drive the absorption chiller. In addition, the system performance is not particularly sensitive to the storage volume whereas the thermal capacity of the solar field is lower than the absorption chiller demand, determining a very discontinuous operation of the chiller itself