Traveling wave type ultrasonic linear motor using twin bending bars

AbstractUltrasonic linear motors with a small body are highly demanded since efficiency does not decrease very much with downsizing. In this study, we aim at realizing ultrasonic linear motor with the diameter less than 10 mm as an alternative to small air cylinder actuators. We propose a new stator structure using two PZT elements between two parallel bending bars. The PZT elements are bonded at the position of several mm from the bar end. In this structure, both bar ends vibrate resonantly in a bending mode, and high vibration displacement amplitude can be obtained along the bars. The length between the PZT element and the bar end determines the optimum driving frequency. The slider simply consists of three metal plates, which sandwich the bending bars, and the preload can be controlled by springs. The conditions in which the traveling wave can be generated along the bars were investigated. When the bars vibrate in a symmetric mode and traveling waves are generated, the slider moves in the direction to the opposite of traveling wave. Traveling wave could be generated by controlling the driving phase difference between the two PZT elements. It was found that the phase differences depend on the distance between the two PZT elements. We experimentally achieved the stroke of 10 mm and the thrust of 78 mN at 23 kHz