AbstractIn the present work, the variation of nose radius on forces, cutting temperature, stress, has been studied using finite element modeling in hot turning operation of Inconel 718. Three values of nose radius were taken (0.4, 0.8 and 1.2mm). Cutting force, thrust force, stress, and cutting temperature have been predicted using commercial DEFORM™ software at different cutting tool nose radius in both room and heated conditions. With the increase of tool nose radius in both room and elevated machining conditions the cutting force and thrust force increased. The cutting temperature, chip thickness and chip tool contact length also have been studied. In order to validate the numerical results an experimental analysis has been performed and...
This paper presents the effect of cutting parameters on the cutting force when machining Inconel 718...
AbstractDuring machining mechanical energy is dissipated into heat by frictional processes and plast...
Challenges for machining include greater and greater material removal rates coupled with an increase...
In the present work, the variation of nose radius on forces, cutting temperature, stress, has been s...
This paper presents a study the effect of nose radius (Rz-mm) on cutting force components and temper...
This paper presents the development of a numerical model for predicting and studying the effects of ...
The present study investigated the performance of three ceramic inserts in terms of the micro-geomet...
ABSTRACT Finite element method (FEM) has been qualified as an excellent method to analyze machining ...
This study presents the finite element analysis of the influence of cutting tool geometrical paramet...
This study involves conducting finite element (FE) analysis on face milling of Inconel 718 and inves...
Inconel is prominently known as a hard material to be machined. Due to stability during extreme temp...
Notch wear and flaking are common tool damage found during end milling.The problems are caused by ab...
As the nose radius increases,the cutting temperature decreases because it changes the situation of t...
There is a need for materials of high hardness and resistance to cutting. As we know the machining o...
This paper presents a study the effect of nose radius (Rz-mm) on the cutting forces during the machi...
This paper presents the effect of cutting parameters on the cutting force when machining Inconel 718...
AbstractDuring machining mechanical energy is dissipated into heat by frictional processes and plast...
Challenges for machining include greater and greater material removal rates coupled with an increase...
In the present work, the variation of nose radius on forces, cutting temperature, stress, has been s...
This paper presents a study the effect of nose radius (Rz-mm) on cutting force components and temper...
This paper presents the development of a numerical model for predicting and studying the effects of ...
The present study investigated the performance of three ceramic inserts in terms of the micro-geomet...
ABSTRACT Finite element method (FEM) has been qualified as an excellent method to analyze machining ...
This study presents the finite element analysis of the influence of cutting tool geometrical paramet...
This study involves conducting finite element (FE) analysis on face milling of Inconel 718 and inves...
Inconel is prominently known as a hard material to be machined. Due to stability during extreme temp...
Notch wear and flaking are common tool damage found during end milling.The problems are caused by ab...
As the nose radius increases,the cutting temperature decreases because it changes the situation of t...
There is a need for materials of high hardness and resistance to cutting. As we know the machining o...
This paper presents a study the effect of nose radius (Rz-mm) on the cutting forces during the machi...
This paper presents the effect of cutting parameters on the cutting force when machining Inconel 718...
AbstractDuring machining mechanical energy is dissipated into heat by frictional processes and plast...
Challenges for machining include greater and greater material removal rates coupled with an increase...