Numerical Modelling of Oxy-Fuel Combustion in a Full-Scale Tangentially-Fired Pulverised Coal Boiler

AbstractThis paper presents a computational fluid dynamics (CFD) modelling study to investigate Victorian brown coal combustion in a 550 MW utility boiler under the air-fired (standard) and three oxy-fuel-fired cases. The standard case was modelled based on the real operating conditions of Loy Yang A power plant located in the state of Victoria, Australia. A level of confidence of the present CFD model was achieved validating four parameters of the standard combustion case, as well as the previous preliminary CFD studies which were conducted on a lab-scale (100kW) unit firing lignite and propane under oxy-fuel-fired scenarios. The oxy-fuel combustion cases are known as OF25 (25vol. % O2 concentration), OF27 (27vol. % O2 concentration), and OF29 (29vol. % O2 concentration). The predictions of OF29 combustion case were considerably similar to the standard firing results in terms of gas temperature levels and radiative heat transfer compared with OF25 and OF27 combustion scenarios. This similarity was because of increasing the residence time of pulverised coal (PC) in the combustion zone and O2 concentration in feed oxidizer gases. Furthermore, a significant increase in the CO2 concentrations and a noticeable decrease in the nitric oxides (NOx) formation were noted under all oxy-fuel combustion conditions. This numerical study of oxy-fuel combustion in a full-scale tangentially-fired PC boiler is important prior to its execution in real-life power plants