AbstractComponents like elbows operating at high temperature in power and petro-chemical industry are vulnerable to failure of crack growth or net section rupture due to a change in geometry or in mode of loading. In this paper, a P91 reheat elbow subjected to internal pressure of 4.63MPa at 569°C for 62,952h in service with a part-through-wall crack located at the outer surface is considered. Prediction of whether the elbow can be used for the next ten years is made. First, the procedure provided by Annex U of BS7910-2005 is employed to conduct the high-temperature defect assessment. And in this assessment, the margin against creep damage, margin against fast fracture evaluated by failure assessment diagram (FAD) and the concept of creep c...
AbstractCoat-hanger dies are widely used in the extrusion of plate and sheet, since it can achieve u...
AbstractIn a 3-part series of papers, of which this paper is Part II, we investigate the applicabili...
AbstractIn the Institute of Construction and Architecture SAS (ICA SAS) we are concerned with an inv...
AbstractCompared to the stable austenitic stainless steels (ASSs), the metastable ASSs, e. g. 304L, ...
AbstractThe cooling effect caused by the Joule-Thomson (JT) effect in the leakage of pressure vessel...
AbstractMany power plant components are subject to combined mechanical and thermal loading condition...
AbstractBased on finite element simulation, the void growth behavior in a 3D cell model subjected to...
AbstractBuckling collapse is one of the important failure modes of pressure vessel. But, in the past...
AbstractBrazing, as one of the major connection technology, has been widely used in different areas ...
AbstractThe advantage of the new compressed natural gas (CNG) marine transportation technology is le...
AbstractWith the development of petroleum, chemical and energy industries and urban gas network, the...
AbstractThis study investigated the potential negative impacts of future UK climate change on dwelli...
AbstractTFA-MOD (Metal Organic Deposition using Trifluoro-acetates) process is of considerable pract...
AbstractThis paper is based on a ductile failure simulation under dynamic loading conditions using f...
AbstractMechanical properties, porosity, and microstructure of Ti6Al4V (ELI) material produced by Se...
AbstractCoat-hanger dies are widely used in the extrusion of plate and sheet, since it can achieve u...
AbstractIn a 3-part series of papers, of which this paper is Part II, we investigate the applicabili...
AbstractIn the Institute of Construction and Architecture SAS (ICA SAS) we are concerned with an inv...
AbstractCompared to the stable austenitic stainless steels (ASSs), the metastable ASSs, e. g. 304L, ...
AbstractThe cooling effect caused by the Joule-Thomson (JT) effect in the leakage of pressure vessel...
AbstractMany power plant components are subject to combined mechanical and thermal loading condition...
AbstractBased on finite element simulation, the void growth behavior in a 3D cell model subjected to...
AbstractBuckling collapse is one of the important failure modes of pressure vessel. But, in the past...
AbstractBrazing, as one of the major connection technology, has been widely used in different areas ...
AbstractThe advantage of the new compressed natural gas (CNG) marine transportation technology is le...
AbstractWith the development of petroleum, chemical and energy industries and urban gas network, the...
AbstractThis study investigated the potential negative impacts of future UK climate change on dwelli...
AbstractTFA-MOD (Metal Organic Deposition using Trifluoro-acetates) process is of considerable pract...
AbstractThis paper is based on a ductile failure simulation under dynamic loading conditions using f...
AbstractMechanical properties, porosity, and microstructure of Ti6Al4V (ELI) material produced by Se...
AbstractCoat-hanger dies are widely used in the extrusion of plate and sheet, since it can achieve u...
AbstractIn a 3-part series of papers, of which this paper is Part II, we investigate the applicabili...
AbstractIn the Institute of Construction and Architecture SAS (ICA SAS) we are concerned with an inv...