AbstractStoichiometric kesterite Cu2ZnSnS4 (CZTS) thin films were successfully synthesized by spray pyrolysis on heated glass under the air atmosphere. The characterization of its structure, morphology, phase constituents, and optical properties were done using powder X-ray diffraction (XRD), Scanning electron microscope (SEM), Energy Dispersive Spectrometer (EDS) and ultraviolet–visible (UV–vis) spectrophotometry, respectively. The X-ray diffraction and Energy Dispersive Spectrometer (EDS) showed single phase with a kesterite structure. The composition of the CZTS thin film was basically corresponds with the theoretical value. Moreover, the prepared products showed the morphology with size ranging from 200–400nm.The observed bandgap of 1.5...
AbstractWe describe a novel apparatus for large-scale production of polarized 3He using Spin-Exchang...
AbstractThe friction and wear properties of acrylonitrile-butadiene-styrene (ABS) filled with micro-...
AbstractLDX 2101 (21,5%Cr, 5%Mn, 1,5%Ni and 0,3%Mo) duplex stainless steel 255x123mm sheets, 10mm th...
AbstractIn the present study, the alloying element Si is blended with (Cr3C2-35% NiCr) powder and th...
AbstractThe nano-scale spatial gap distributions on apical-fluorine multi-layered cuprate supercondu...
AbstractThe decrease in flying height due to the higher recording areal density of hard disk drives ...
AbstractAustenitic stainless steels (SS) with appropriate mechanical and irradiation-resistant prope...
AbstractA set-up for optical gas composition measurement based on absorption spectroscopy is compose...
AbstractThe increasing use of biomass as a fuel is leading to higher fireside corrosion of the heat ...
AbstractPrecise measurements of magnetic moment relaxation of YBa2Cu3O7-δ films were carried out in ...
AbstractThe present work reports the effect of cold rolling and subsequent annealing at different te...
AbstractThe paper aims at assessing the influence of the Size-Effect (SE) parameter on the VHCF resp...
AbstractThis paper discusses latest results obtained in micro hole percussion drilling in stainless ...
AbstractA cascading network of decentralized detention-based green/gray infrastructure (DBGI) is dem...
AbstractThe physicochemical properties of soil amended by composted sewage sludge and the growth of ...
AbstractWe describe a novel apparatus for large-scale production of polarized 3He using Spin-Exchang...
AbstractThe friction and wear properties of acrylonitrile-butadiene-styrene (ABS) filled with micro-...
AbstractLDX 2101 (21,5%Cr, 5%Mn, 1,5%Ni and 0,3%Mo) duplex stainless steel 255x123mm sheets, 10mm th...
AbstractIn the present study, the alloying element Si is blended with (Cr3C2-35% NiCr) powder and th...
AbstractThe nano-scale spatial gap distributions on apical-fluorine multi-layered cuprate supercondu...
AbstractThe decrease in flying height due to the higher recording areal density of hard disk drives ...
AbstractAustenitic stainless steels (SS) with appropriate mechanical and irradiation-resistant prope...
AbstractA set-up for optical gas composition measurement based on absorption spectroscopy is compose...
AbstractThe increasing use of biomass as a fuel is leading to higher fireside corrosion of the heat ...
AbstractPrecise measurements of magnetic moment relaxation of YBa2Cu3O7-δ films were carried out in ...
AbstractThe present work reports the effect of cold rolling and subsequent annealing at different te...
AbstractThe paper aims at assessing the influence of the Size-Effect (SE) parameter on the VHCF resp...
AbstractThis paper discusses latest results obtained in micro hole percussion drilling in stainless ...
AbstractA cascading network of decentralized detention-based green/gray infrastructure (DBGI) is dem...
AbstractThe physicochemical properties of soil amended by composted sewage sludge and the growth of ...
AbstractWe describe a novel apparatus for large-scale production of polarized 3He using Spin-Exchang...
AbstractThe friction and wear properties of acrylonitrile-butadiene-styrene (ABS) filled with micro-...
AbstractLDX 2101 (21,5%Cr, 5%Mn, 1,5%Ni and 0,3%Mo) duplex stainless steel 255x123mm sheets, 10mm th...