Fatigue crack nucleation and propagation in aluminum alloy plates with cold expanded holes

AbstractAnalysis of the literature shows that in some cases existing technological methods of processing, including cold expansion, are the effective means to improve fatigue durability of structural elements with holes. The effect of cold expansion (1−3 %) on the stress state and fatigue durability of aluminum plates with functional holes under uniaxial cyclic loading was studied. The fatigue crack growth in the plates with a thickness t = 6 mm and width of 60 mm with a central hole diameter of 8 mm and 10 mm of aluminum alloy D16chТ (2024-T3) was investigated. Fatigue test was carried out under constant amplitude loading at stress ratio R = σmin/σmax = 0 and room temperature. Here σmin, σmax are the minimum and maximum stresses, respectively. The stress range was 147 MPa, loading frequency was 25 Hz. The mechanical properties of the alloy at room temperature were: yield strength σY = 300 MPa, tensile strength σU = 430 MPa. For all tested specimens with cold expanded holes the cracks initiation from the edges of holes on the entrance faces mandrel and from middle part for plain hole. Using the finite element method, the distribution of local residual stresses in the vicinity of the expanded hole was calculated. For specimens with cold expanded holes the least compressive stresses were near the entrance face and the largest were in the middle of the hole and near the exit face. With the increase of the cold expansion hole, the difference in values of compressive residual stress along the plate thickness is reduced. The width zone of residual compressive stresses increase with the increase of cold expansion. The dependencies of the number of cycles to crack initiation in aluminum specimens on the local maximum stress and local stresses range in the vicinity of surface hole were obtained. Cold expansion degree of 1% increases the lifetime of the plates to the initiation of fatigue crack length of 0.25 mm in 1.5-3 times as compared with plane plates. A similar dependence is observed for cold expansion of 2%. With further increase of cold expansion degree up to 3% the lifetime to fatigue crack initiation is increased in 7−10 times as compared with plane plate. By using the finite element method, the distributions of local stress range, maximum and minimum local stress near the hole depending on the number of loading cycles and cold expansion were built. In the middle section of the specimen the local stress ratio in the second half-cycle of load decrease with increasing of distance from the edge of the hole and with the increase of cold expansion. The lowest value of local stress ratio was obtained at cold expansion degree of 3% and it is constant across thickness of plate