This study describes an experimental comparison of the tribological behavior of three coatings for advanced applications. In particular, couplings of steel with coatings in cast and electroplated bronze, and in WC/C were tested by means of a reciprocating apparatus and a pin-on-disc test rig. Different sliding velocities were applied and the dynamic coefficient of friction estimated. Additionally, comparative evaluations of the wear behavior were carried out. The results pointed out a better performance of the WC-C coating compared to the others, showing both a lower coefficient of friction and lower wear, under almost all tested conditions
Friction and abrasive wear response of WC-12 Co and Cr3C2-25 NiCr coatings was studied. Abrasive wea...
A series of experimental tests were carried out using turned and ground mild steel surfaces rubbing ...
The tribological behavior of CuSn7 Bronze and Steel 20MnCr5 couple was studied as a function of mech...
This study describes an experimental comparison of the tribological behavior of three coatings for a...
Dry sliding wear tests on specimens of mild steel (MS) and WC coated mild steel (MSC) specimens were...
International audienceThe present study is conducted in order to compare the frictional and wear beh...
Tribological characteristics of steel combinations are observed in this study using rotating tribome...
Diamond like carbon (DLC or a-C:H) coatings can help to solve friction and wear problems. The improv...
The purpose of this study is to investigate comparative tribological behaviours of PVD hard coatings...
A series of experimental tests were carried out using turned and ground mild steel surfaces rubbing ...
The paper presents the results of tests of sliding wear of bronze coatings made on the surface of sp...
AbstractCoated bearing surfaces exhibit relatively better tribological properties compared with non-...
MX 2 (M=Mo, W; X=S, Se) and DLC(a-C: H and WC/C) are two kinds of typical low friction coatings wide...
AbstractSeveral works on friction coefficient during abrasive wear tests are available in the litera...
In this work different evaluation methods for thin hard coatings were studied in three laboratories....
Friction and abrasive wear response of WC-12 Co and Cr3C2-25 NiCr coatings was studied. Abrasive wea...
A series of experimental tests were carried out using turned and ground mild steel surfaces rubbing ...
The tribological behavior of CuSn7 Bronze and Steel 20MnCr5 couple was studied as a function of mech...
This study describes an experimental comparison of the tribological behavior of three coatings for a...
Dry sliding wear tests on specimens of mild steel (MS) and WC coated mild steel (MSC) specimens were...
International audienceThe present study is conducted in order to compare the frictional and wear beh...
Tribological characteristics of steel combinations are observed in this study using rotating tribome...
Diamond like carbon (DLC or a-C:H) coatings can help to solve friction and wear problems. The improv...
The purpose of this study is to investigate comparative tribological behaviours of PVD hard coatings...
A series of experimental tests were carried out using turned and ground mild steel surfaces rubbing ...
The paper presents the results of tests of sliding wear of bronze coatings made on the surface of sp...
AbstractCoated bearing surfaces exhibit relatively better tribological properties compared with non-...
MX 2 (M=Mo, W; X=S, Se) and DLC(a-C: H and WC/C) are two kinds of typical low friction coatings wide...
AbstractSeveral works on friction coefficient during abrasive wear tests are available in the litera...
In this work different evaluation methods for thin hard coatings were studied in three laboratories....
Friction and abrasive wear response of WC-12 Co and Cr3C2-25 NiCr coatings was studied. Abrasive wea...
A series of experimental tests were carried out using turned and ground mild steel surfaces rubbing ...
The tribological behavior of CuSn7 Bronze and Steel 20MnCr5 couple was studied as a function of mech...