Optimum cutting conditions for turned components

This paper describes the procedures used in a technologically orientated numerically controlled (NC) system to determine the optimum cut ling conditions automatically for turning, drilling, grooving, threading and parting-of operations. In rough turning, the optimum depth and feed combination is determined using a direct search procedure on the allowable depthlfeed region for chip control. The system determines the optimum depth of cut, feed and velocity for each pass in multi-pass turning on the basis of a user-selected objective criterion and a number of technological limitations that may apply to the process, such as machine power, dynamic instability, allowable range of depths und feeds for the tool and workholding limitations which include axial slip, circumferential slip and component throwout. A user-friendly manual option is also provided which allows the user to specify the cutting parameters. Examples are given to illustrate how these procedures determine the optimum cutting conditions. A comparison between the machining costs and times using cutting conditions obtained from handbooks and the aforementioned procedures shows that for all the operations considered, there are cost and time savings when the cutting conditions obtained by the latter are used. NOTATION depth of cut (mm) minimum and maximum feasible depths for roughing (mm) minimum and maximum feasible depth