The programs and activities described herein were supported in part by funds provided by the United States Department of the Interior as authorized under the Water Resources Act of 1964, Public Law 88-379. Neutron count data for calibration purposes ~ere collected by neutron logging in 4 boreholes ~ and porosity data ~ere deter-mined from photo logs run on the same 4 boreholes. A neutron count-porosity calibration curve was constructed and ~as found to take the form of the logarithm of n~dtron count versus poros-ity. The calibration cUPVe ~as calculated by linear regression analysis ~ utilising empirical field data. The calibration curve is valid ~thin the expressed 95 percent confidence intervals only for neutron logs from (1) basaltic for...
A neutron gauge must be calibrated before it can be used to measure volumetric water content. Calibr...
Several methods for obtaining soil samples for determining soil water content were used for field ca...
A 6445-foot test well was completed on April 27, 1976 in the Puna Area of Hawaii as part of an exten...
Neutron count data for calibration purposes were collected by neutron logging in 4 boreholes, and po...
In 1970, the Water Resources Research Center initiated a study of neutron well logging techniques in...
The lack of calibration to a wide range of well conditions has limited the application of the Univer...
The use of drilling and coring methods that minimize the disturbance of formation rock and core has ...
During the evaluation of a proposed site for an underground nuclear test at the Department of Energy...
This report describes the 1991 yearly calibration of a gross gamma-ray geophysical pulse logging sys...
11. To determine porosity from a gamma-gamma log, one must have a. Data for grain density. b. Calibr...
In 1966, the Water Resources Research Center initiated a comprehensive study of electric well-loggin...
Borehole geophysical logging for site characterization in the volcanic rocks at the proposed nuclear...
A new method of measuring the continuously variable hydraulic conductivity at 20 cm increments surro...
Neutron and density logs acquired in boreholes at Yucca Mountain, Nevada are used to determine poros...
The calculation of elasticity parameters by sonic and ultra sonic wave propagation in saturated soil...
A neutron gauge must be calibrated before it can be used to measure volumetric water content. Calibr...
Several methods for obtaining soil samples for determining soil water content were used for field ca...
A 6445-foot test well was completed on April 27, 1976 in the Puna Area of Hawaii as part of an exten...
Neutron count data for calibration purposes were collected by neutron logging in 4 boreholes, and po...
In 1970, the Water Resources Research Center initiated a study of neutron well logging techniques in...
The lack of calibration to a wide range of well conditions has limited the application of the Univer...
The use of drilling and coring methods that minimize the disturbance of formation rock and core has ...
During the evaluation of a proposed site for an underground nuclear test at the Department of Energy...
This report describes the 1991 yearly calibration of a gross gamma-ray geophysical pulse logging sys...
11. To determine porosity from a gamma-gamma log, one must have a. Data for grain density. b. Calibr...
In 1966, the Water Resources Research Center initiated a comprehensive study of electric well-loggin...
Borehole geophysical logging for site characterization in the volcanic rocks at the proposed nuclear...
A new method of measuring the continuously variable hydraulic conductivity at 20 cm increments surro...
Neutron and density logs acquired in boreholes at Yucca Mountain, Nevada are used to determine poros...
The calculation of elasticity parameters by sonic and ultra sonic wave propagation in saturated soil...
A neutron gauge must be calibrated before it can be used to measure volumetric water content. Calibr...
Several methods for obtaining soil samples for determining soil water content were used for field ca...
A 6445-foot test well was completed on April 27, 1976 in the Puna Area of Hawaii as part of an exten...