The effects of high temperature creep on the microstructure and the grain boundaries of the oxide-dispersion-strengthened superalloy MA6000 are investigated by means of transmission electron microscopy. Rafting of the γ′ phase is observed in the elongated grains, whereas in the small non-recrystallized grains γ′ rafting does not occur. Dislocations form networks around γ′ precipitates only in particular areas of the coarse grains where the oxide particles are absent. In the rest of the areas, where oxide dispersion is homogeneous, dislocations are pinned to the hard oxide particles instead of accumulating at γ-γ′ interfaces. Dislocation networks around the γ′ phase are not observed in the small grains. There is no detectable influence of hi...
International audienceSeveral microstructural parameters of the NR6 nickel-based superalloy were var...
International audienceThe high-temperature creep behavior of a rafted [001] oriented AM1 Ni-based si...
The study carried out during this thesis consists in analyzing the micromechanisms that control the ...
Cast nickel-based superalloys are used for blades in land-based, energy conversion and powerplant ap...
High-resolution scanning transmission electron microscopy (STEM) has been used to study the structur...
Creep deformation substructures in the superalloy René 88 DT have been investigated after small-stra...
Creep tests were performed on MC2 single crystal superalloy at 950°C/200 MPa and 1150°C/80 MPa under...
This paper presents results from a research initiative aimed at investigating high temperature creep...
International audienceTransmission electron microscopy (TEM) experiments combining conventional and ...
The microstructure of the oxide-dispersion strengthened (ODS) superalloy Inconel MA 6000 was studied...
International audienceCreep tests have been performed on MC2 single crystal superalloy at 950°C/200 ...
Der Kriechbruch der oxiddispersionsgehärteten Superlegierung INCONEL MA 6000 wurde als Funktion der ...
International audienceThe high temperature creep properties of next generation cast and wrought AD73...
In the field of aircraft engines, grain boundary defects lead to a high scrap rate when producing si...
AbstractThe creep behavior of the DZ125 superalloy at high temperatures has been investigated based ...
International audienceSeveral microstructural parameters of the NR6 nickel-based superalloy were var...
International audienceThe high-temperature creep behavior of a rafted [001] oriented AM1 Ni-based si...
The study carried out during this thesis consists in analyzing the micromechanisms that control the ...
Cast nickel-based superalloys are used for blades in land-based, energy conversion and powerplant ap...
High-resolution scanning transmission electron microscopy (STEM) has been used to study the structur...
Creep deformation substructures in the superalloy René 88 DT have been investigated after small-stra...
Creep tests were performed on MC2 single crystal superalloy at 950°C/200 MPa and 1150°C/80 MPa under...
This paper presents results from a research initiative aimed at investigating high temperature creep...
International audienceTransmission electron microscopy (TEM) experiments combining conventional and ...
The microstructure of the oxide-dispersion strengthened (ODS) superalloy Inconel MA 6000 was studied...
International audienceCreep tests have been performed on MC2 single crystal superalloy at 950°C/200 ...
Der Kriechbruch der oxiddispersionsgehärteten Superlegierung INCONEL MA 6000 wurde als Funktion der ...
International audienceThe high temperature creep properties of next generation cast and wrought AD73...
In the field of aircraft engines, grain boundary defects lead to a high scrap rate when producing si...
AbstractThe creep behavior of the DZ125 superalloy at high temperatures has been investigated based ...
International audienceSeveral microstructural parameters of the NR6 nickel-based superalloy were var...
International audienceThe high-temperature creep behavior of a rafted [001] oriented AM1 Ni-based si...
The study carried out during this thesis consists in analyzing the micromechanisms that control the ...