An investigation of the electrolytic plasma oxidation process for corrosion protection of pure magnesium and magnesium alloy AM50.

In this study, silicate and phosphate EPO coatings were produced on pure magnesium using an AC power source. It was found that the silicate coatings possess good wear resistance, while the phosphate coatings provide better corrosion protection. A Design of Experiment (DOE) technique, the Taguchi method, was used to systematically investigate the effect of the EPO process parameters on the corrosion protection properties of a coated magnesium alloy AM50 using a DC power. The experimental design consisted of four factors (treatment time, current density, and KOH and NaAlO2 concentrations), with three levels of each factor. Potentiodynamic polarization measurements were conducted to determine the corrosion resistance of the coated samples. The optimized processing parameters are 12 minutes, 12 mA/cm2 current density, 0.9 g/l KOH, 15.0 g/l NaAlO2. The results of the percentage contribution of each factor determined by the analysis of variance (ANOVA) imply that the KOH concentration is the most significant factor affecting the corrosion resistance of the coatings, while treatment time is a major factor affecting the thickness of the coatings. (Abstract shortened by UMI.)Dept. of Electrical and Computer Engineering. Paper copy at Leddy Library: Theses & Major Papers - Basement, West Bldg. / Call Number: Thesis2005 .M323. Source: Masters Abstracts International, Volume: 44-03, page: 1479. Thesis (M.A.Sc.)--University of Windsor (Canada), 2005