The Waste Calcining Facility (WCF) is located at the Idaho Nuclear Technology and Engineering Center. In 1998, the WCF was closed under an approved Hazardous Waste Management Act/Resource Conservation and Recovery Act (HWMA/RCRA) Closure Plan. Vessels and spaces were grouted and then covered with a concrete cap. The Idaho Department of Environmental Quality issued a final HWMA/RCRA post-closure permit on September 15, 2003, with an effective date of October 16, 2003. This permit sets forth procedural requirements for groundwater characterization and monitoring, maintenance, and inspections of the WCF to ensure continued protection of human health and the environment. The post-closure permit also includes semiannual reporting requirements un...
Environmental mercury measurements were started in Fy-01 at the Idaho National Engineering Laborator...
The mission of the Reduced Enrichment for Research and Test Reactors (RERTR) Program is to minimize ...
This technical document contains the Justification for the Class III Permit Modification request for...
This report is a compilation of the groundwater sampling results from three monitoring wells located...
This Closure Report (CR) describes the closure activities performed at CAU 528, Polychlorinated Biph...
Elephant and rhinoceros dung was used to investigate the feasibility of generating methane from the ...
Denitrification woodchip bioreactors, a relatively new technology for edge-of-field treatment of sub...
This Closure Report (CR) describes the activities performed to close CAU 115, Area 25 Test Cell A Fa...
This source-term summary document is intended to describe the current understanding of contaminant s...
This project has focused on better understanding the potential impact of On-Farm Flood Capture and R...
The Idaho Cleanup Project has prepared this interim control strategy for the U.S. Department of Ener...
Environmental monitoring data were collected at and around the Area 3 and Area 5 Radioactive Waste M...
This study is part of a long-term research program designed to identify and quantify acid rain damag...
The Kentucky Geological Survey and the Kentucky Division of Water are evaluating groundwater quality...
DOE Order 5820.2A requires that low-level waste (LLW) disposal sites active on or after September 19...
Environmental mercury measurements were started in Fy-01 at the Idaho National Engineering Laborator...
The mission of the Reduced Enrichment for Research and Test Reactors (RERTR) Program is to minimize ...
This technical document contains the Justification for the Class III Permit Modification request for...
This report is a compilation of the groundwater sampling results from three monitoring wells located...
This Closure Report (CR) describes the closure activities performed at CAU 528, Polychlorinated Biph...
Elephant and rhinoceros dung was used to investigate the feasibility of generating methane from the ...
Denitrification woodchip bioreactors, a relatively new technology for edge-of-field treatment of sub...
This Closure Report (CR) describes the activities performed to close CAU 115, Area 25 Test Cell A Fa...
This source-term summary document is intended to describe the current understanding of contaminant s...
This project has focused on better understanding the potential impact of On-Farm Flood Capture and R...
The Idaho Cleanup Project has prepared this interim control strategy for the U.S. Department of Ener...
Environmental monitoring data were collected at and around the Area 3 and Area 5 Radioactive Waste M...
This study is part of a long-term research program designed to identify and quantify acid rain damag...
The Kentucky Geological Survey and the Kentucky Division of Water are evaluating groundwater quality...
DOE Order 5820.2A requires that low-level waste (LLW) disposal sites active on or after September 19...
Environmental mercury measurements were started in Fy-01 at the Idaho National Engineering Laborator...
The mission of the Reduced Enrichment for Research and Test Reactors (RERTR) Program is to minimize ...
This technical document contains the Justification for the Class III Permit Modification request for...