The DZERO VLPC Cryostat and the Superconducting Solenoid both require an insulating Vacuum of 10{sup -5} Torr or less. There is a vacuum system on the Detector Platform consisting of 2 Turbomolecular vacuum pumps and their associated piping, valves, instrumentation that are dedicated to this task. This vacuum equipment requires an operator interface and control logic in order to function properly. The operator interface allows an operator to monitor, control and configure the proper pumping setup required at any given time. The control logic is needed to protect the Vacumm vessels and Vacuum equipment from catastrophic events that may harm them. This is typically done with interlock chains or strings
A vacuum-pump control system has been developed using programmable-logic controllers (PLC) for the 2...
NASA Stennis Space Center's (SSC's) large rocket engine test facility requires the use of liquid pro...
This document provides the calculations used to determine the error of safety class signals used for...
The Dzero detector is scheduled for a major upgrade between 1996 and 1999. This note describes the s...
This procedure is used when it is necessary to operate the solenoid energization, controls, interloc...
This engineering note documents a communication link between the D0 cryo/gas control system and the ...
This document has served as the specification for the energization, control, interlocking and quench...
Currently, Fermi National Accelerator Laboratory is in the midst of a site wide upgrade. Here at D-Z...
The reliability of large vacuum systems is largely dependent on procedures established during instal...
The initial vacuum pumping of the fully loaded cryostats immediately upon completing the minimum hea...
The cooldown will be immediately preceded by two trial pump downs; the insulating vacuum and the det...
The D0 cryogenic control system has 3 I/O bases and 1 25 amp 24vdc power supply. Each I/O base uses ...
This article describes the design and evaluation of a CMOS-based control system for use in Cryogenic...
The Safety Class Instrumentation and Control (SCIC) system provides active detection and response to...
In the LHC beam pipes and cryostats, the pressure measurement covers a wide range, from 1500 mbar do...
A vacuum-pump control system has been developed using programmable-logic controllers (PLC) for the 2...
NASA Stennis Space Center's (SSC's) large rocket engine test facility requires the use of liquid pro...
This document provides the calculations used to determine the error of safety class signals used for...
The Dzero detector is scheduled for a major upgrade between 1996 and 1999. This note describes the s...
This procedure is used when it is necessary to operate the solenoid energization, controls, interloc...
This engineering note documents a communication link between the D0 cryo/gas control system and the ...
This document has served as the specification for the energization, control, interlocking and quench...
Currently, Fermi National Accelerator Laboratory is in the midst of a site wide upgrade. Here at D-Z...
The reliability of large vacuum systems is largely dependent on procedures established during instal...
The initial vacuum pumping of the fully loaded cryostats immediately upon completing the minimum hea...
The cooldown will be immediately preceded by two trial pump downs; the insulating vacuum and the det...
The D0 cryogenic control system has 3 I/O bases and 1 25 amp 24vdc power supply. Each I/O base uses ...
This article describes the design and evaluation of a CMOS-based control system for use in Cryogenic...
The Safety Class Instrumentation and Control (SCIC) system provides active detection and response to...
In the LHC beam pipes and cryostats, the pressure measurement covers a wide range, from 1500 mbar do...
A vacuum-pump control system has been developed using programmable-logic controllers (PLC) for the 2...
NASA Stennis Space Center's (SSC's) large rocket engine test facility requires the use of liquid pro...
This document provides the calculations used to determine the error of safety class signals used for...