Work of Adhesion Measurements of Silicone Networks Using Contract Mechanics

Work of adhesion (Wa) measurements are being studied for several types of polymer/metal combinations in order to obtain a better understanding of the adhesive failure mechanisms for systems containing encapsulated and bonded components. A primary concern is whether studies of model systems can be extended to systems of technological interest. One study performed in our laboratory involved the determination of Wa between silicone (PDMS) and Al surfaces in order to establish potential adhesive failure mechanisms. Our initial work with PDMS was based on Dow Corning 170 Sylgard. PDMS hemispheres were synthesized following the procedure outlined by Chaudhury and Whitesides where the filler was stripped from the commercial silicone by centrifuging. Wa between PDMS surfaces was determined using the JKR method. Our results for the Wa of PDMS were in agreement with those reported by Chaudhury and Whitesides. However, further JKR studies using these PDMS hemispheres on flat Al surfaces were fraught with difficulty. We could not discriminate hydrogen-bonding effects between Al{sub 2}O{sub 3} and hydroxyl groups in the PDMS and other possible bonding mechanisms. It was suggested that commercial systems contain inhibitors and additives that interfere with understanding the PMDS/Al interface. Therefore, the current study uses pure PDMS networks synthesized in our lab. Also, two contact mechanics methods were deployed to measure the Wa--JKR method using two hemispheres and a LEFM method using a cylinder containing a circumferential crack. This paper contains a description of the synthesis of the PDMS used for these studies and the determination of Wa between PDMS surfaces using the JKR method, contact angle measurements, and a LEFM method that consists of a cylinder containing a circumferential crack