Molten salt oxidation of chloro-organic compounds: Experimental results for product gas compositions and final forms studies

Molten salt oxidation (MSO) has been selected as a promising technology for treatment of some US Department of Energy (DOE) mixed wastes. Mixed wastes are defined as those wastes that contain both radioactive components, which are regulated by the Atomic Energy Act of 1954, and hazardous waste components, which are regulated under the Resource Conservation and Recovery Act (RCRA). Oak Ridge National Laboratory (ORNL) has installed and operated a bench-scale MSO apparatus to obtain experimental information needed before the design and construction of an MSO pilot plant. The primary objective of the experiments performed was to show that dioxin and furan emissions from a molten salt oxidation (MSO) unit were below the proposed regulatory limit of 0.1 ng/m{sup 3} as 2,3,7,8-tetrachlorodibenzo-para-dioxin equivalents or toxic equivalence quotient. The feed stream was to contain 2,4-dichlorophenol, a suspected precursor to the formation of dioxin and furans. The tests were to be done over a range of salt compositions and flow rates expected in a pilot- or full-scale MSO unit. Two other objectives were to demonstrate destruction and removal efficiencies (DREs) greater than US Environmental Protection Agency requirements and to show that levels of products of incomplete combustion (PICs) are the same as, or lower than, those observed in incinerators for two common waste constituents [carbon tetrachloride (CCl{sub 4}) and CH{sub 3}CCl{sub 3}]. A final objective was to perform some initial studies of final waste forms using sulfur polymer cement (SPC). This report presents the results from the operation of the bench-scale MSO system