Kinetics of MN based sorbents for hot coal gas. Quarterly report, September--December 1996

Manganese-based sorbents have been investigated for the removal of hydrogen sulfide (the primary sulfur bearing compound) from hot coal gases prior to its use in combined cycle turbines. Four formulations of Mn-based sorbents were tested in an ambient-pressure fixed-bed reactor to determine steady state H{sub 2}S concentrations, breakthrough times and effectiveness of the sorbent when subjected to cyclic sulfidation and regeneration testing. In a previous report, the sulfidation results were presented. Manganese-based sorbents with molar ratios > 1:1 Mn:Substrate were effective in reducing the H{sub 2}S concentration in simulated coal gases to less than 100 ppmv over five cycles. Actual breakthrough time for formulation C6-2-1100 was as high as 73% of breakthrough time based on wt% Mn in sorbent. In this report, the regeneration results will be presented. Regeneration tests determined that loaded pellets can be fully regenerated in air/steam mixture at 750{degrees}C with minimal sulfate formation. 16 refs., 9 figs., 5 tabs