Add to ORKGAn investigation is made of the buckling of the compression cover of post-stiffened box beams subjected to end moments. Charts are presented for the determination of the minimum post axial stiffnesses and the corresponding compressive buckling loads required for the compression cover to buckle with nodes through the posts. Application of the charts to design and analysis and the limitations of their use are discussed
This paper is the second part of a series of reports on the inward bulge type buckling of monocoque ...
Available theories and test data on buckling of curved plates and shells are reviewed. For torsion a...
The work described in this thesis is concerned with the effect of including pre-buckling deformation...
An investigation is made of the buckling of the compression cover of post-stiffened box beams subjec...
The local buckling of stiffener sections and the buckling of plates with sturdy stiffeners are revie...
A monocoque box beam consisting of a 24S-T aluminum-alloy sheet reinforced by four bulkheads and by ...
A criterion is developed for the stiffness required of elastic lateral supports at the ends of a com...
A stability analysis is made of a long flat rectangular plate subjected to a uniform longitudinal co...
In open box beams subjected to torsion, secondary stresses arise owing to lateral bending of the spa...
The distribution of stress in the cover sheets of thin-wall box beams is analyzed, with regard to th...
The present report contains a set of charts developed for computing the fixity effect on a compressi...
Results are presented for a part of a test program on 24S-T aluminum alloy flat compression panels w...
The charts presented give the compressive buckling coefficients for a single-truss-core and a double...
ABSTRACT: The aim of this study was to explore easy technologies for manufacturing of integral compo...
ABSTRACT: The aim of this study was to explore easy technologies for manufacturing of integral compo...
This paper is the second part of a series of reports on the inward bulge type buckling of monocoque ...
Available theories and test data on buckling of curved plates and shells are reviewed. For torsion a...
The work described in this thesis is concerned with the effect of including pre-buckling deformation...
An investigation is made of the buckling of the compression cover of post-stiffened box beams subjec...
The local buckling of stiffener sections and the buckling of plates with sturdy stiffeners are revie...
A monocoque box beam consisting of a 24S-T aluminum-alloy sheet reinforced by four bulkheads and by ...
A criterion is developed for the stiffness required of elastic lateral supports at the ends of a com...
A stability analysis is made of a long flat rectangular plate subjected to a uniform longitudinal co...
In open box beams subjected to torsion, secondary stresses arise owing to lateral bending of the spa...
The distribution of stress in the cover sheets of thin-wall box beams is analyzed, with regard to th...
The present report contains a set of charts developed for computing the fixity effect on a compressi...
Results are presented for a part of a test program on 24S-T aluminum alloy flat compression panels w...
The charts presented give the compressive buckling coefficients for a single-truss-core and a double...
ABSTRACT: The aim of this study was to explore easy technologies for manufacturing of integral compo...
ABSTRACT: The aim of this study was to explore easy technologies for manufacturing of integral compo...
This paper is the second part of a series of reports on the inward bulge type buckling of monocoque ...
Available theories and test data on buckling of curved plates and shells are reviewed. For torsion a...
The work described in this thesis is concerned with the effect of including pre-buckling deformation...