This paper describes a simple method for modeling the performance of an Inductive Output Tube (IOT). The model reproduces the characteristics of an IOT with good accuracy over the full dynamic range of the tube
The principle of Inductive Power Transfer (IPT) is very old but it is rarely used for transferring p...
Thesis (Ph.D.)-University of Natal, Durban,1994.As a design and analysis aid for the development of ...
For the TESLA linear collider 1.3 GHz RF sources with 10 MW peak power and about 70 % efficiency are...
A simple method for modeling the performance of an inductive output tube (IOT) is described. The mod...
An Inductive Output Tube (IOT) differs from a klystron in several aspects which require special trea...
There is an increasing requirement within the particle accelerator community for CW RF power sources...
We have recently developed a simplified model and a set of simple formulas for inductive voltage add...
During the Phase I program, CCR completed several major building blocks for a 3D large signal, induc...
High power radio-frequency systems, as typically used in fusion research devices, utilize vacuum tub...
This program investigated development of a multiple beam inductive output tube (IOT) to produce 30 M...
This paper proposes a technique to estimate the equivalent reflected impedance on the transmit side ...
The efficiencies of a microwave power tube with a multistage depressed collector and of the power su...
The principle of Inductive Power Transfer (IPT)is very old but it is rarely used for transferring po...
Inductive voltage adder topology has attracted great attentions in pulse power community for near tw...
A set of codes for the numerical simulation of a gridded Inductive Output Amplifier has been develop...
The principle of Inductive Power Transfer (IPT) is very old but it is rarely used for transferring p...
Thesis (Ph.D.)-University of Natal, Durban,1994.As a design and analysis aid for the development of ...
For the TESLA linear collider 1.3 GHz RF sources with 10 MW peak power and about 70 % efficiency are...
A simple method for modeling the performance of an inductive output tube (IOT) is described. The mod...
An Inductive Output Tube (IOT) differs from a klystron in several aspects which require special trea...
There is an increasing requirement within the particle accelerator community for CW RF power sources...
We have recently developed a simplified model and a set of simple formulas for inductive voltage add...
During the Phase I program, CCR completed several major building blocks for a 3D large signal, induc...
High power radio-frequency systems, as typically used in fusion research devices, utilize vacuum tub...
This program investigated development of a multiple beam inductive output tube (IOT) to produce 30 M...
This paper proposes a technique to estimate the equivalent reflected impedance on the transmit side ...
The efficiencies of a microwave power tube with a multistage depressed collector and of the power su...
The principle of Inductive Power Transfer (IPT)is very old but it is rarely used for transferring po...
Inductive voltage adder topology has attracted great attentions in pulse power community for near tw...
A set of codes for the numerical simulation of a gridded Inductive Output Amplifier has been develop...
The principle of Inductive Power Transfer (IPT) is very old but it is rarely used for transferring p...
Thesis (Ph.D.)-University of Natal, Durban,1994.As a design and analysis aid for the development of ...
For the TESLA linear collider 1.3 GHz RF sources with 10 MW peak power and about 70 % efficiency are...
DOI
Add to ORKG