GEOMETRIC PARAMETERIZATION OF THE SLIDE

Namen diplomskega dela je bil razvoj parametričnega modela paha. Da bi lahko nalogo izpeljali, je bilo potrebno predhodno ugotoviti parametre, na podlagi katerih se pah zgradi. Ideja je temeljila na želji, da bi z nastavitvijo parametričnega modela paha podjetju omogočili enostavnejšo, hitrejšo in učinkovitejšo konstruiranje ter izdelavo pahov. Z natančnim pregledom literature smo analizirali, kaj je potrebno storiti za izdelavo želenega modela paha. Z znanimi podatki smo konstruirali parametiziran model paha, ga analizirali, če ustreza, ter preverili, če sta bila konstruiranje in nastavitev parametrov uspešna. Konstruiranemu parametričnemu modelu paha je bila dodana interna standardizacija komponent ter MKE analiza. Z MKE analizo smo preverili trdnost paha. S tem delom bo podjetju Litostroj Ravne d. o. o. pri razvijanju novih stiskalnic omogočeno hitrejše in učinkovitejše konstruiranje pahov. V pomoč mu bo tudi pri izdelavi tehniške dokumentacije pahov.The purpose of the thesis was to develop a parametric model of the slide. For the task to be carried out it was necessary to pre-determine the parameters on which the slide is build. The idea was based on the desire to make the manufacture and the design of the slides easier, faster and more efficient for the company, by adjusting the parametric model of the slide. With a proper review of the literature I was able make a good analysis of what needed to be done in order to produce the desired model of the slide. Using already known data I made a parameterized model of the slide and wanted to know if it is running properly and if the making and setting of the parameters was successful. Internal standardization of components and FEM analysis have been added to the complete parametric model of the slide. I checked the structural stability of the slide with the FEM analysis. I believe that faster and more efficient development of new presses will now be possible for the Litostroj Ravne d.o.o. company. It will also assist in the making of the technical documentation for the slides.the design of the slides easier, faster and more efficient for the company by adjusting the parametric model of the slide. With a proper review of the literature I could make a good analysis of what needed to be done to produce the desired model of the slide. Using already known data I made a parameterized model of the slide and wanted to know if it is running properly, and if the making and setting of the parameters were successful. Internal standardization of components and FEM analysis have been added to the complete parametric model of the slide. I checked the structural stability of the slide with the FEM analysis. I believe that faster and more efficient development of new presses will now be possible for the Litostroj Ravne d.o.o. company. It will also assist in the making of the technical documentation for the slides