Study on Structure and Vacuum Membrane Distillation Performance of PVDF Composite Membranes: Influence of Molecular Weight and Blending

In this study, membranes were made from three polyvinylidene fluoride (PVDF) polymers individually and the blend systems of high (H) and low (L) molecular weight PVDF by phase inversion process. After investigating membrane casting solutions’ viscous and thermodynamic properties, the membranes so fabricated were characterized by scanning electron microscopy, gas permeation tests, porosity measurement, contact angle (CA) and liquid entry pressure of water (LEPw) measurement, and further subjected to vacuum membrane distillation (VMD) in a scenario that was applicable for cooling processes, where the feed water temperature was maintained at 27℃. It was found that PVDF solutions’ viscosities and thermodynamic instabilities were determined by the types of PVDF employed in single polymer systems and the mixing ratios of two PVDF polymers in blend systems. Thus the membrane properties and performances were influenced by the aforesaid factors as well. In single polymer systems, it was found that the membrane surface roughness and porosity increased with an increase in molecular weight. Among all the membranes casted in this study, the water vapor flux of VMD was found to be the highest at the intermediate range of H:L ratio, i.e., 4:6, at which the thickness of the sponge-like layer showed a minimum, the finger-like macro-voids formed a more orderly single-layer structure, and the LEPw showed a minimum. A conclusion can be made that blend systems of high molecular weight PVDF polymers and low molecular weight PVDF polymers could be used to optimize membrane performance in vacuum membrane distillation