Long Hallucal Tendon Force Vectors and First Metatarsophalangeal Deformity After Hallux Valgus Surgery

Category: Midfoot/Forefoot Introduction/Purpose: Recurrence is one of the most common complications following hallux valgus surgery. Moreover, hallux varus occurs in cases of overcorrection. We aimed to quantitatively measure, using radiographic examination, the dynamics of the soft tissues that act on deformities (recurrence of valgus and occurrence of varus) after the surgery. Methods: This retrospective single-institution study included 60 patients (98 feet) who underwent hallux valgus surgery between 2009 and 2018. According to radiographic findings of the foot under weightbearing conditions at postoperative month 1, we examined the tendons’ pathway and calculated the forces on the first metatarsophalangeal joint, which we termed the deformity force angle (DFA). We compared whether there was a significant difference in DFAs between the groups in which deformities occurred and those in which deformities did not occur after correction. In addition, the DFA was compared to known radiographic measurements of hallux valgus recurrence (hallux valgus angle, distal metatarsal articular angle, intermetatarsal angle, and sesamoid position) to assess association with recurrence. Results: We observed a significant difference in the DFA between patients with and without hallux valgus recurrence (P < .001) and between those with and without hallux varus (P < .001) based on standing radiographs taken at a minimum of 6 months postoperation. For predicting the deformities, the areas under the curve were 0.863 (hallux valgus recurrence) and 0.831 (hallux varus occurrence), respectively, which was greater than other factors evaluated. The DFA values greater than 9.5 degrees and less than 5.5 degrees were associated with the recurrence of valgus and occurrence of varus, respectively. Conclusion: In our study, DFA was associated with hallux valgus recurrence when it exceeded 9.5 degrees and hallux varus when it was less than 5.5 degrees. Moreover, in the hallux valgus surgery we performed, a DFA from 5.5 to 9.5 degrees appeared to be a “safe zone” for preventing early deformity after surgery