Experimental Study into the Mechanical Properties of Plastic Concrete: Compressive Strength Development over Time, Tensile Strength and Elastic Modulus

Plastic Concrete is a low-strength (fcm,28d≤ 1.0 MPa), low-stiffness, impervious concrete used for cut-off wall construction in earthen dams. To date, there has been no systematic study on the effect of mix design on the long-term time development of the mechanical properties (compressive strength, tensile strength, and elastic modulus) of Plastic Concrete. Therefore currently no Plastic Concrete specific constitutive law for cut-off wall design exists. The present study closes this gap. Ten Plastic Concrete mixes with two bentonite-cement ratios and three types of sodium bentonite were produced. Fresh concrete workability tests were performed for all mixes. Compressive strength tests were performed at ages 28 d, 56 d, 91 d and four years. Splitting tensile strength and elastic modulus tests were performed at 28 days. The workability results show a good linear correlation between slump and flow table tests. Plastic Concrete’s compressive strength development over time is notably slower than that of ordinary concrete, and a new time development model following fib MC 2020 is established using a fitted sC coefficient. The splitting tensile strength shows an overall good, linear correlation with compressive strength, with an approximate ratio of 0.135. Furthermore, the elastic modulus EC,S according to EN 12390-13 concrete tests show significantly higher elastic modulus than the available data, and a model approximation for the elastic modulus EC,S as a function of compressive strength is also provided. Overall, this study provides the first Plastic Concrete specific mechanical property models, confirming the critical role mix design plays on Plastic Concrete’s short and long-term mechanical properties. Thus, the developed models enable a more realistic Plastic Concrete cut-off wall design and provide an important basis for future research