Microwave pulse compression using a helically corrugated waveguide

There has been a drive in recent years to produce ultrahigh power short microwave pulses for a range of applications. These high-power pulses can be produced by microwave pulse compression. Sweep-frequency based microwave pulse compression using smooth bore hollow waveguides is one technique of passive pulse compression, however, at very high powers, this method has some limitation due to its operation close to cutoff. A special helical corrugation of a circular waveguide ensures an eigenwave with strongly frequency dependent group velocity far from cutoff, which makes the helically corrugated waveguide attractive for use as a passive pulse compressor for very high-power amplifiers and oscillators. The results of proof-of-principle experiments and calculations of the wave dispersion using a particle in cell particle-in-cell (PIC) code are presented. In the experiments, a 70-ns 1-kW pulse from a conventional traveling-wave tube (TWT) was compressed in a 2-m-long helical waveguide. The compressed pulse had a peak power of 10.9 kW and duration of 3 ns. In order to find the optimum pulse compression ratio, the waveguide's dispersion characteristics must be well known. The dispersion of the helix was calculated using the PIC code Magic and verified using an experimental technique. Future work detailing plans to produce short ultrahigh power gigawatt (GW) pulses will be discussed