Growth of Chromium Carbide in a Hot Wall DLICVD Reactor

International audienceChromium carbide coatings were grown at 748 K in a hot wall CVD reactor fed by sublimation of bis(benzene)chromium, BBC (MOCVD) and by direct liquid injection using a BBC/toluene solution (DLICVD). The two types of coatings exhibit an amorphous structure and the same C content (22 at.%). DLICVD permits delivering higher mass flow rate of precursors and consequently the growth rate is 3 times higher and the thickness uniformity is better than using MOCVD. Chromium metal deposition has also been investigated by DLICVD in this hot wall reactor using BBC/toluene/additive as precursor. The purpose of the additive is to block carbide formation. Two additives have been studied: (i) hexachlorobenzene (C6Cl65 and (ii) thiophenol (C6H5SH). The ratio additive/BBC required for Cr metal deposition is a few percent. In this process, C6Cl6 is not decomposed and only traces of Cl (0.4 at.%) are found in the coatings. For a ratio C6Cl6/BBC > 27% the growth of any coating is blocked. The gas phase containing C6H5SH is more reactive since the onset of deposition occurs approximately 50 K before the temperature of the chlorinated compound. Furthermore, a sulfur contamination of 3 at.% has been analyzed in the coatings revealing a partial decomposition of the additive. The results are detailed and discussed in relation with previous works