Colony screening by PCR

Author: Matt Lewis ### Notes This is the fastest way to screen bacterial colonies. Our PCR machine takes 24 tubes so I routinely screen 22 colonies + 1 negative + 1 positive control. ### Choosing the primers Ideally you want a primer pair that can only work if the correct construct is present eg. a vector flanking primer and a gene specific primer. However, this may not allow you a positive control (essential) so you might have to use both vector flanking primers instead. If you have enough space in your PCR machine you could do both. ### Typical Protocol 1. Set up 24 PCR tubes each containing 5 µl H2O. - Touch a fresh toothpick (or yellow tip) onto a colony, dip it into a PCR tube, then streak it onto a fresh replicate agar plate using a numbered template (that is, all 24 colonies on a single agar plate). - I don't label the PCR tubes. I can tell what number they are and also whether they have been 'dipped' by their position in the rack/block. - Repeat this for the 22 (or whatever) colonies - for tube 23 (negative control) use a colony that is negative (or use nothing). - for tube 24 (positive control) use a colony that will yield a product with your primers. - If you don't have a +ve colony then use a tiny amount of plasmid DNA - Incubate the replicate agar plate at 37°C. - These streaked colonies will be visible within 6–8 hours so you can set up overnight miniprep cultures on the same day. - Set up a 25 x PCR pre-mix as follows:  Add 15 µl of pre-mix to each PCR tube. PCR program:  This PCR should take less than 2 hours. While the PCR is running prepare the agarose gel ready to analyze the PCR products. When you have the result you can go to the replica agar plate on the same day and set up miniprep cultures of the likely candidate colonies