HyUSPRe Report & Data on 'New experimental data on reactions between H2 and well cement and effects on fluid flow and mechanical properties of well cement

In this study, new experimental data is presented of the effects of H2 exposure and cyclic loading on mechanical properties of oil well (class G) cement, relevant for underground hydrogen storage operations. Changes in mechanical properties (Young’s modulus, Poisson’s ratio and ultimate strength) have been analyzed using unconfined compressive strength (UCS) tests and confined cyclic loading tests on class G cement samples that were unreacted (cured for 3 days at 80°C) and exposed to lime-saturated brine and N2 or H2 for 1 and 2 months. Changes in cement mineralogy were analyzed by XRD analysis of the unreacted and exposed samples. The mechanical properties of elastic modulus and Poisson’s ratio are within the expected range of an oil well cement. Differences in Young’s modulus, Poisson’s ratio and ultimate strength are limited between unreacted, N2-exposed and H2-exposed samples, when comparing UCS tests or confined cyclic loading tests. Repeated UCS tests seem to indicate that the variation in Young’s modulus and ultimate strength increases after N2 and H2 exposure, but this observation needs to be confirmed in additional tests. During cyclic axial loading of confined cement samples, irreversible (plastic) deformation (compaction) occurs that affect static Young’s modulus. Also, effects of exceeding yield and failure strength on Young’s modulus are observed. Dynamic Young’s moduli and Poisson’s ratios derived from acoustic velocity measurements during confined cyclic tests show limited variation, in particular if static and dynamic Young’s modulus are compared. The mineralogical changes as identified using XRD analysis suggest minor changes between unexposed and H2- and N2-exposed samples, although XRD patterns indicate some minerals that could not be identified. The main conclusion is that effects of H2 exposure and cyclic loading on mechanical properties and mineralogical changes of class G cement is limited compared to unreacted or N2 exposed samples for the investigated conditions. There is no indication that changes in mechanical properties of cement are such that cement integrity of wells used for underground hydrogen storage will be significantly affected. It should be emphasized that this conclusion is based on experiments on one type of cement (class G) and a limited set of conditions. In particular, additional tests to assess the reproducibility of current results and tests on samples that were exposed longer to H2 and N2 are of interest. Detailed effects of changing properties for the durability and integrity of wells can be derived by performing a parameter sensitivity analysis with well integrity modelling for the range in mechanical properties measured in this study