Evaluation of Thermal and Electrical Conductivity of Carbon-based PLA Nanocomposites for 3D Printing

PLA nanocomposites for fused-deposition modeling (FDM) technique are considered. Thermal and electrical conductivity of carbon-based PLA nanocomposites are investigated looking at the different morphological characteristic of the carbon nanoparticles. In particular commercial multi-walled carbon nanotubes (CNTs) and graphene nanoplates (GNPs) are considered as filler in order to realize filament for 3D printed devices for electrical and thermal application. In this paper a filler concentration up to 12% in weight is investigated. Transient Plane Source (TPS) measurements of thermal conductivity show that better heat conduction is obtained through the incorporation in the PLA matrix of carbonaceous nanostructures with predominantly two-dimensional shape (GNPs). DC electrical measurements show that the nanocomposite filled with the predominant mono-dimensional carbon nanoparticle (i.e. CNT) exhibits lower electrical percolation threshold, whereas a greater post percolation electrical conductivity is established with the two-dimensional filler (i.e. GNP). Such characteristics are to be considered in order to make robust and cost effective 3D printed device, by preferring 1D filler or 2D filler for electrical or thermal application respectively. Moreover, multiphase nanocomposites obtained with an optimized combination of CNT and GNP nanoparticles could be exploited to realize devices for joint electrical and thermal application