FEM modelling techniques for simulation of 3D concrete printing

Three-dimensional concrete printing (3DCP) has gained a lot of popularity in recent years. According to many, 3DCP is set to revolutionize the construction industry: yielding unparalleled aesthetics, better quality control, lower cost,and a reduction of the construction time. In this paper, two finite element method (FEM) strategies are presented for simulating such 3D concrete printing processes. The aim of these models is to predict the structural behaviour during printing, while the concrete is still fresh, and estimate the optimal print speed and maximum overhang angle to avoid print failures. Both FE analyses involve solving multiple static implicit steps where sets of finite elements are added stepwise until failure. The main difference between the two methods is in the discretization of the 3D model. The first method uses voxelization to approximate the 3D shape, while the second approach starts from defining the toolpath and constructs finite elements by sweeping them along the path. A case study is presented to evaluate the effectiveness of both strategies. Both models are in good agreement with each other, and a comparable structural response is obtained. The model's limitations and future challenges are also discussed. Ultimately, the paper demonstrates how FEM-based models can effectively simulate complex prints and could give recommendations with regards to a better print strategy. These suggestions can be related to the maximum printing speed and overhang angle, but also the optimal layer height and thickness, the specific choice of the infill pattern, or by extension the mixture design. When print failures can be avoided, this methodology could save time, resources and overall cost. Future work will focus on the validation of these numerical models and comparing them to experimental data.Three-dimensional concrete printing (3DCP) has gained a lot of popularity in recent years. According to many, 3DCP is set to revolutionize the construction industry: yielding unparalleled aesthetics, better quality control, lower cost,and a reduction of the construction time. In this paper, two finite element method (FEM) strategies are presented for simulating such 3D concrete printing processes. The aim of these models is to predict the structural behaviour during printing, while the concrete is still fresh, and estimate the optimal print speed and maximum overhang angle to avoid print failures. Both FE analyses involve solving multiple static implicit steps where sets of finite elements are added stepwise until failure. The main difference between the two methods is in the discretization of the 3D model. The first method uses voxelization to approximate the 3D shape, while the second approach starts from defining the toolpath and constructs finite elements by sweeping them along the path. A case study is presented to evaluate the effectiveness of both strategies. Both models are in good agreement with each other, and a comparable structural response is obtained. The model's limitations and future challenges are also discussed. Ultimately, the paper demonstrates how FEM-based models can effectively simulate complex prints and could give recommendations with regards to a better print strategy. These suggestions can be related to the maximum printing speed and overhang angle, but also the optimal layer height and thickness, the specific choice of the infill pattern, or by extension the mixture design. When print failures can be avoided, this methodology could save time, resources and overall cost. Future work will focus on the validation of these numerical models and comparing them to experimental data.C