Effects of build positions on the thermal history, crystallization, and mechanical properties of polyamide 12 parts printed by Multi Jet Fusion

Multi Jet Fusion (MJF) has gradually been utilised for the commercial fabrication of final products. In particular, the mechanical properties of MJF-printed polyamide 12 (MJF PA12) parts have been widely investigated by manipulating the process parameters such as the printing orientation and the cooling rate. In this work, the effects of build positions on the thermal history, crystallization, and mechanical properties of MJF PA12 parts were investigated. The thermal history of printed parts was obtained using the MJF Thermal Prediction Engine software developed by Hewlett-Packard HP Labs (HP Inc.). As compared to the parts printed at the boundaries, those in the centre region experienced a slower cooling rate, which was favourable for crystal growth. Both the crystallite size and crystallinity of the parts in the centre region were larger than those of the parts at the boundaries. The parts printed in the centre region had slightly higher tensile modulus and significantly smaller elongation at break and strain energy density than those printed at the boundaries. The tensile strength of the parts at different locations was comparable. This work serves as a guide to selecting the build position of MJF-printed parts to achieve desirable mechanical properties.Published versionThis work was supported by Industry Alignment Fund-Industry Collaboration Projects Grant: [Grant Number I1801E0028]