Add to ORKGThe paper discusses the potential of pressure slip casting for components made of technical ceramic materials. The tests carried out on pressure slip casting and pressure filtration of silicon nitride show that the highest green density will be obtained if a slurry is used which is completely deflocculated and does not contain any binding agent. Penetration of fine particles into the porous plastic mould cannot be completely prevented but can be reduced to a large extent by the proper selection of the pressure-time regim
The dispersing behaviour of silicon, silicon carbide and their mixtures in aqueous media were monito...
The dispersion behaviour of SiC, Si and their mixtures, in deionised water, was studied as a functio...
The porosity of the slip cast Si3N4 is similar to that of pressed Si3N4 formed at 2500 kg/sq cm. The...
Pressure casting is a forming method which has been known for a long time. This forming technique ha...
Slip casting is a well established technique for the manufacture of traditional ceramic bodies, such...
This report describes the consolidation behaviour of Si3N4 dispersions during pressure casting. Disp...
Nous avons étudié les caractéristiques des suspensions aqueuses de deux poudres de nitrure de silici...
The slip casting studies on well optimised slips of Sic, Si3N 4 and silicon have been applied to fab...
The optimum conditions of aqueous silicon slips for slip13; casting was achieved by employing variou...
The dispersing behavior of silicon, silicon carbide and their mixtures in aqueous media were monitor...
Aqueous slips of silicon carbide, silicon nitride and silicon have been optimised by using a simple,...
Owing to its unique properties, silicon nitride is a frequently used materials choice in highly dema...
The dispersability of Si and Si3N4 powders in aqueous media was monitored by particle-size distribut...
Fabrication of silicon preforms of high green density (> 1.2 g/cm3) by slip casting of silicon (in a...
The aim of the presented investigation was to further improve a novel shot peening technique in orde...
The dispersing behaviour of silicon, silicon carbide and their mixtures in aqueous media were monito...
The dispersion behaviour of SiC, Si and their mixtures, in deionised water, was studied as a functio...
The porosity of the slip cast Si3N4 is similar to that of pressed Si3N4 formed at 2500 kg/sq cm. The...
Pressure casting is a forming method which has been known for a long time. This forming technique ha...
Slip casting is a well established technique for the manufacture of traditional ceramic bodies, such...
This report describes the consolidation behaviour of Si3N4 dispersions during pressure casting. Disp...
Nous avons étudié les caractéristiques des suspensions aqueuses de deux poudres de nitrure de silici...
The slip casting studies on well optimised slips of Sic, Si3N 4 and silicon have been applied to fab...
The optimum conditions of aqueous silicon slips for slip13; casting was achieved by employing variou...
The dispersing behavior of silicon, silicon carbide and their mixtures in aqueous media were monitor...
Aqueous slips of silicon carbide, silicon nitride and silicon have been optimised by using a simple,...
Owing to its unique properties, silicon nitride is a frequently used materials choice in highly dema...
The dispersability of Si and Si3N4 powders in aqueous media was monitored by particle-size distribut...
Fabrication of silicon preforms of high green density (> 1.2 g/cm3) by slip casting of silicon (in a...
The aim of the presented investigation was to further improve a novel shot peening technique in orde...
The dispersing behaviour of silicon, silicon carbide and their mixtures in aqueous media were monito...
The dispersion behaviour of SiC, Si and their mixtures, in deionised water, was studied as a functio...
The porosity of the slip cast Si3N4 is similar to that of pressed Si3N4 formed at 2500 kg/sq cm. The...