Energy efficiency improvement of water pumping system using synchronous reluctance motor fed by perovskite solar cells

Perovskite solar cells (PSCs) are in the forefront of third-generation of photovoltaics and gained a lot of attention as a very promising green technology toward direct solar energy conversion to electricity. PSCs are fabricated following solution-processed techniques at low temperature and they present high power conversion efficiency exceeding 25%, enabling them to be attractive alternative to the silicon-based devices. This research work proposes an efficient and cost-effective photovoltaic (PV) pumping system based on PSCs. For this purpose, lab-scale PSCs were fabricated and their characteristics were determined. In parallel, the geometry of a synchronous reluctance motor (SynRM) driving a 350 m(3)/day water pump was optimized for maximizing the output power, while minimizing the torque ripple simultaneously. In addition, a perovskite solar array feeding the SynRM via an inverter was designed and implemented. The inverter was properly regulated by a control system which optimized the maximum available power of the PSCs solar array and the SynRM characteristics. Finally, laboratory measurements were performed, including a power generator simulating the behavior of the PSCs array feeding the SynRM. The obtained results confirmed the experimental validation of the proposed approach.Perovskite solar cells (PSCs) are in the forefront of third-generation of photovoltaics and gained a lot of attention as a very promising green technology toward direct solar energy conversion to electricity. PSCs are fabricated following solution-processed techniques at low temperature and they present high power conversion efficiency exceeding 25%, enabling them to be attractive alternative to the silicon-based devices. This research work proposes an efficient and cost-effective photovoltaic (PV) pumping system based on PSCs. For this purpose, lab-scale PSCs were fabricated and their characteristics were determined. In parallel, the geometry of a synchronous reluctance motor (SynRM) driving a 350 m(3)/day water pump was optimized for maximizing the output power, while minimizing the torque ripple simultaneously. In addition, a perovskite solar array feeding the SynRM via an inverter was designed and implemented. The inverter was properly regulated by a control system which optimized the maximum available power of the PSCs solar array and the SynRM characteristics. Finally, laboratory measurements were performed, including a power generator simulating the behavior of the PSCs array feeding the SynRM. The obtained results confirmed the experimental validation of the proposed approach.A