Optimization of Cutting Parameters Using Taguchi Method During the Face Milling of AISI 1040 with Coated and Uncoated Inserts

AISI 1040 carbon steel is used in many different sectors such as mold sets, automobile components, transmission shafts, rails and gears. The use of this material in different sectors, its behaviors in the various machining operations have become important. In this study, face milling process was applied to AISI 1040 carbon steel material by using coated and uncoated cutting inserts. Experiments were performed on the basis of Taguchi’s L18 orthogonal array (OA) at different levels of the cutting inserts (Uncoated carbide, CVD / TiN-TiCN-Al2O3 coated carbide and PVD/TiALN coated carbide), the cutting speeds (160, 180 and 220 m/min) and the feed rate (0.1, 0.15 and 0.3 mm/tooth) and depth of cut (0.3 and 0.6 mm). The obtained values at the end of the experiments were evaluated through the signal to noise (S/N) ratios and Analysis of Variance (ANOVA). The end of the confirmation experiments, the surface roughness of 2.90 µm could be significantly improved to 1.42 µm with an enhanced performance of 51.03%