On model based aero engine diagnostics

Maintenance and diagnostics play a vital role in the aviation sector. This is especially true for the engines, being one of the most vital components. Lack of maintenance, or poor knowledge of the current health status of the engines, may lead to unforeseen disruptions and possibly catastrophic effects. To keep track of the health status, and thereby supporting maintenance planning, model based diagnostics is a key factor. In the work going into this thesis, various aspects of model based gas turbine diagnostics, focused on aero engines, are covered. First, the importance of knowing what health parameters may be derived from a set of measurements is addressed. The selected combination is herein denoted as a matching scheme. A framework is proposed where the most suitable matching scheme is selected for a numerically robust diagnostic system. If a sensor malfunction is detected, the system automatically adapts. The second subject is a system for detecting a burn-through of an afterburner inner liner. This kind of burn-through event has a very small impact on available on-board measurements, making it difficult to detect numerically. A method is proposed performing back-to-back testing after each engine start. The method has shown potential to detect major burn-through events under the preconditions, regarding data collection time and frequency. Increasing these will allow for more accurate estimations. The third subject covers the importance of knowing the airplane installation effects. These are generally the intake pressure recovery, bleed and shaft power extraction. Just like inaccurate measurements affect diagnostic results, so does erroneous installation effects. A method for estimating said effects in the presence of gradual degradation has been proposed by using neural networks. By retraining the networks throughout the degradation process, the estimation errors is reduced, ensuring relevant estimations even at severe degradations. Finally, an issue related to the general lack of on-board measurements for diagnostics is addressed. Due to lack of measurements, the diagnostic model tend to be underdetermined. A least square solver working without a priori information has been implemented and evaluated. Results from the solver is very much dependent on available instrumentation. In well instrumented components, such as the compressors, good diagnostic accuracy was achieved while the turbine health estimations suffer from smeared out results due to poor instrumentation