Deformation Rate and Temperature Sensitivity in TWIP/TRIP VCrFeCoNi Multi-Principal Element Alloy

High-entropy alloys (HEAs) and medium-entropy alloys (MEAs), also sometimes referred to as multi-principal element alloys (MPEAs), present opportunities to develop new materials with outstanding mechanical properties. Through the careful selection of constituent elements along with optimized thermal processing for proper control of structure, grain size, and deformation mechanisms, many of the newly developed HEA systems exhibit superior strength and ductility levels across a wide range of temperatures, particularly at cryogenic deformation temperatures. Such a remarkable response has been attributed to the hardening capacity of many MPEAs that is achieved through the activation of deformation twinning. More recent compositions have considered phase transforming systems, which have the potential for enhanced strengthening and therefore high strength and ductility levels. However, the strain rate sensitivity of such transforming MPEAs is not well understood and requires further investigation. In this study, the tensile properties of the non-equiatomic V10Cr10Fe45Co30Ni5 MPEA were investigated at different deformation rates and temperatures ranging from 77 K (−196 °C) to 573 K (300 °C). Depending on the deformation temperature, the considered MPEA exhibits plasticity through either crystallographic slip, deformation twinning, or solid-state phase transformation. At 300 °C, only slip-mediated plasticity was observed for all the considered deformation rates. Deformation twinning was detected in samples deformed at room temperature, while face-centered cubic to body-centered cubic phase transformation became more favorable at cryogenic deformation temperatures. The trends are nonlinear with twinning-induced plasticity (TWIP) favored at the intermediate deformation rate, while transformation-induced plasticity (TRIP) was observed, although limited, only at the slowest deformation rate. For all the considered deformation rates at cryogenic deformation temperature, a significant TRIP activity was always detected. The extent of TRIP, however, was dependent on the deformation rate. Increasing the deformation rate is not conducive to TRIP and thus hinders the hardening capacity