Multicellular Cell Seeding on a Chip: New Design and Optimization towards Commercialization

This paper shows both experimental and in-depth theoretical studies (including simulations and analytical solutions) on a microfluidic platform to optimize its design and use for 3D multicellular co-culture applications, e.g., creating a tissue-on-chip model for investigating diseases such as pulmonary arterial hypertension (PAH). A tissue microfluidic chip usually has more than two channels to seed cells and supply media. These channels are often separated by barriers made of micro-posts. The optimization for the structures of these micro-posts and their spacing distances is not considered previously, especially for the aspects of rapid and cost-efficient fabrication toward scaling up and commercialization. Our experimental and theoretical (COMSOL simulations and analytical solutions) results showed the followings: (i) The cell seeding was performed successfully for this platform when the pressure drops across the two posts were significantly larger than those across the channel width. The circular posts can be used in the position of hexagonal or other shapes. (ii) In this work, circular posts are fabricated and used for the first time. They offer an excellent barrier effect, i.e., prevent the liquid and gel from migrating from one channel to another. (iii) As for rapid and cost-efficient production, our computer-aided manufacturing (CAM) simulation confirms that circular-post fabrication is much easier and more rapid than hexagonal posts when utilizing micro-machining techniques, e.g., micro-milling for creating the master mold, i.e., the shim for polymer injection molding. The findings open up a possibility for rapid, cost-efficient, large-scale fabrication of the tissue chips using micro-milling instead of expensive clean-room (soft) lithography techniques, hence enhancing the production of biochips via thermoplastic polymer injection molding and realizing commercialization